I am trying to make a 3 node Hamachi Gateway network (all 3 nodes in different locations), I will add as much information as I can about each node.
Currently only Node 2 can communicate with the gateway (Node 1). Node 2 can access network drives and servers on the gateway network (192.168.1.X).
Node 3 can’t communicate with gateway or any servers on it. (Or ping their 192.168.1.x addresses)
Node 3 has firewall configured and has no errors/warning in “Hamachi Self-Diagnosis”
--------------------------------------------------------------------------------------------
Node 1:
Debian 9.2.1 Linux (Set as Gateway)
AMD Geode LX 800 (500MHz Processor)
Hamachi 2.1.0.174-1_i386
Haguichi 1.3.8 GUI
Computer is on a 192.168.1.X network and is allocated an IP via local router DHCP
IPv4 with CGNAT Global IP address
--------------------------------------------------------------------------------------------------
Node 2:
My laptop (works)
Windows 10 32bit
Hamachi Windows
IPv4 Routing Table
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 192.168.178.1 192.168.178.137 50
0.0.0.0 0.0.0.0 25.0.0.1 25.79.99.99 9256
Hamachi Virtual Adapter
IPv4 Address. . . . . . . . . . . : 25.79.99.99(Preferred)
Hamachi Virtual Adapter 2
IPv4 Address. . . . . . . . . . . : 192.168.1.99(Preferred)
-------------------------------------------------------------------------------------------
Node 3:
Other Client (Not working)
Windows 10 64bit
Hamachi Windows
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 192.168.1.254 192.168.1.109 35
Hamachi Virtual Adapter
IPv4 Address. . . . . . . . . . . : 25.29.99.88(Preferred)
Hamachi Virtual Adapter 2
IPv4 Address. . . . . . . . . . . : 10.40.1.242(Preferred)
------------------------------------------------------------------------------------------
From what I can see, Hamachi Virtual Adapter 2 on Node 3 should be 192.168.1.X, but isn’t.
Node 3 has a Windows IPsec VPN configured in "Network & Internet Settings", but it's not active/connected.
What could be wrong?